Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1a. Screw cam bolts (BB) all the way into the small holes
located on side panel left (C) and side panel right (D)
as shown figure.
1b. Insert the wood dowels (CC) into the end holes as a
guide, attach stretcher (B) to the side panel left (C)
and side panel right (D) by engaging cam locks (AA).
Hardware Used
AA
Cam lock
BB
Cam bolt
CC
Wood dowel
2a. Screw cam bolts (BB) all the way into the small holes
located on top panel (A).
2b. Insert the wood dowels (CC) into the holes pre-drilled
on top edge of assembled frame.
2c. Position the top panel (A) onto the inserted dowels
and attach in place by engaging cam locks (AA) as
shown figure.
Hardware Used
AA
Cam lock
BB
Cam bolt
CC
Wood dowel
3a. Insert the wood dowels (CC) into the holes pre-drilled
on bottom edge of assembled frame.
3b. Position the bottom panel (F) onto the inserted
dowels and attach in place by engaging M4 x 50 mm
screws (DD) as shown figure.
Hardware Used
CC
Wood dowel
M4 x 50 mm
DD
Screw
1
AA
B
x 2
C
x 2
D
x 2
2
BB
CC
A
x 6
C
x 6
D
B
x 6
3
C
D
CC
x 4
x 4
7
ASSEMBLY INSTRUCTIONS
4a. Expand the back panel (G) and lay it onto the back
edges of assembled frame making sure the margins
CC
along all edges are equal.
4b. There are pilot holes on the side panel, please align
with back panel pre-drilled holes when assemble with
M3.5 x 15 mm screws (FF).
BB
Hardware Used
FF
M3.5 x 15 mm Screw
If you plan to use this unit as hutch (stand this on another
one), please skip step 5 & 6.
AA
5. Insert floor levelers (GG) into the bottom of bottom
panel (F).
Hardware Used
GG
Floor Leveler
6. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
F
DD
4
G
x 20
5
x 4
GG
6
x 4
HH
8
FF
F
A
Publicidad
