Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Insert the wire stopper (H) into the holes of the shoe
shelf (E).
The shelf can be used as regular shelf by removing the
wire stopper.
8a. Set the rear shelf pin (KK) to one hole higher than the
front shelf pin. Tilt and install shoe shelves (E) in place.
8b. Plug the plastic covers (II) onto the visible cams locks
to conceal the cams.
Hardware Used
II
Plastic cover
KK
Shelf pin
9. This cabinet was designed with a feature that
allows stacking two units. Additional units sold
separately. Insert wood dowels (CC) into the holes
on top of the base unit. Place bottom of second unit
onto the inserted dowels. Secure units together by
attaching the metal plates (EE) at both ends with the
M3.5 x 19 mm screws (LL) into the pre-drilled holes.
NOTE: Remove caps (HH) before stacking two units
together.
Hardware Used
CC
Wood dowel
EE
Metal plate
LL
M3.5 x 19 mm Screw
7
E
x 4
8
E
II
E
x 4
E
x 16
E
9
CC
x 4
x 1
x 4
9
ASSEMBLY INSTRUCTIONS
10a. Adjust floor levelers to level the unit against the wall
where desired.
10b. Using back stretcher (B) as a template, mark three
holes to indicate where holes will be drilled.
H
10c. Drill three pilot holes into the wall where previously
marked.
10d. Make sure that the drilled holes fit the wall anchors
properly.
10e. Press the anchors into the holes and gently tap with
a hammer until flush in the holes. PLEASE NOTE: If the
mounting hole coincides with a wooden stud, there is no
need for a wall anchor.
10f. Align back stretcher (B) and back crossers (MM) over
the drywall anchors (NN) and secure with M5 x 65 mm
screw (JJ).
10g. Tighten screws securely with Phillips screwdriver.
If you want this unit flush against the wall, you can cut away the baseboard of the wall, and then
secure with M5 x 65 mm screw (JJ) without back crosser (MM).
Hardware Used
M5 x 65 mm
JJ
Screw
MM
Back Crosser
KK
NN
Drywall Anchor
LL
EE
10
NN
MM
B
JJ
x 3
x 3
x 3
10
Wall
Publicidad
