Publicidad
Idiomas disponibles
Idiomas disponibles
or explode.
Never throw rechargeable batteries into fire
„
or water.
Do not expose the rechargeable batteries to
„
mechanical stress.
z Risk of leakage from
rechargeable batteries
Avoid exposing rechargeable batteries to
„
extreme conditions and temperatures, e.g.
radiators or direct sunlight.
Avoid contact with skin, eyes and mucous
„
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged rechargeable
batteries can cause chemical burns
if they come into contact with skin.
Therefore, wear suitable protective gloves in
such cases.
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material.
Check that all package contents are
„
present.
Check if the product or individual parts are
„
damaged. Should you detect damage, do
not use the product. Please contact the
retailer via the service address indicated.
The product can be attached to a magnetic
surface via the magnet
Make sure you protect the surface if it is of a
type that marks easily. Make sure that the
surface is flat and level to ensure the light is
firmly attached. Alternatively, the cordless
work lamp can also be attached by means
of the hook
(see Fig. C).
8
48
GB/IE/NI/CY/MT
(see Fig. C).
7
z Charging the battery
If the lamp is on, switch it off by pressing
„ „
the ON/OFF button
Place the USB charging holder
„ „
D) on a flat, level surface, making sure to
protect the surface if it is of a type that
marks easily.
Place the cordless work lamp
„ „
charging holder supplied
Now connect the USB charging cable
to the USB-C port
11
holder
and connect the other end of the
9
cable to a standard SELV USB interface.
The battery will then start charging. The
„ „
battery charge level of the cordless work
lamp
is indicated by the blue flashing
1
light of the three-level charge status
indicator
(see Fig. B).
5
Level one
= approx. 35 %,
Level two
= approx. 67 %,
Level three
= 100 %
The USB charging holder
„ „
standby LED
(see Fig. D) that indicates
10
when it is ready for use. The standby LED
is permanently on whenever the USB
10
charging holder
9
power source.
The cordless work lamp can also be
„ „
charged without the USB charging holder.
To do so, connect the USB charging cable
to the USB-C port
12
standard SELV USB interface.
Please note: The product cannot be
switched on during charging process, so
continuous operation is not possible.
z Switching the cordless work
lamp ON/OFF
Unfold the cordless work lamp.
„ „
The ON/OFF button
„ „
cordless work lamp on/off and also
controls its brightness. The battery charge
level is indicated by the charge status
indicator
(see Fig. B). Pressing the ON/
5
�
4
(see Fig.
9
in the USB
1
(see Fig. D).
9
12
on the USB charging
has a red
9
is connected to a
(see Fig. B) and a
6
switches the
4
Publicidad
