Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONS AND CONNECTIONS
1
SETUP
PAIRING YOUR DMX FIXTURE
1 ∙ Connect the transmitter (DMX-WT) to your DMX controller OUTPUT and the receiver to your DMX fixture.
2 ∙ Power up transmitter and receiver using the power adaptor included in the box.
3 ∙ Press and hold 4 seconds on receiver button
(this means that receiver is now ready to be paired).
4 ∙ Press now on transmitter button
mitter in blue color and receiver in green color). The pairing is processing. Once paring is done, the transmit-
ter status LED is now fixed blue color and receiver status LED is fixed green color. If Transmitter or receiver
looses DMX signal, the status LED will blink slowly.
ADD A FIXTURE IN AN ACTIVE GROUP.
1 ∙ Press and hold 4 seconds on receiver button
(this means that receiver is now ready to be paired).
2∙ Press now on transmitter button
mitter in blue color and receiver in green color). The pairing is processing. Once paring is done, the transmit-
ter status LED is now fixed blue color and receiver status LED is fixed green color. The other fixtures already
paired in this group with this transmitter remain paired of course.
SET UP A NEW GROUP
To set up a new group is very easy. You need one more transmitter. Keep the existing groups active , and start the
procedure above called « Pairing your DMX fixture».
2
3
4
5
6
to reset the pairing until the status LED
5
to start pairing. Both receiver and transmitter will blink rapidly (trans-
5
to reset the pairing until the status LED
5
to start pairing. Both receiver and transmitter will blink rapidly (trans-
5
DESCRIPTION - RECEIVER
1
3-pin XLR female connector
2
Recessed power on/off button
3
Battery level indicator light
4
Power connector
5
Recessed group button
6
Group indicator
P.12
becomes white.
3
becomes white.
3
Publicidad
