Stiga CG 20 Li Manual De Instrucciones página 35

o) If the output polarity does not match the charging
polarity, Do not use the charger.
p) Do not open the cover under any circumstances. If the
cover is damaged, the charger can no longer be used.
q) The charger external flexible cable cannot be replaced;
if the cable is damaged, the whole charger must be
disposed of (for CG 20 Li ,CGD 20 Li).
If the cord set is damaged, it must be replaced
by a special cord set available from the
manufacturer or its service agent
(for CG 20 Li B).
r) The line voltage can be disconnected by pulling the
mains socket.
s) Before using the charger, check the available voltage in
each country.
t) Do not mount the charger on the wall. Place it on a flat,
solid surface.
2.2 ENVIRONMENTAL PROTECTION
AND DISPOSAL
Do not throw electrical equipment
away
observance
2012/19/EU on electrical and electronic
equipment waste and its implementation,
in observance of UK Regulation "The
waste electrical and electronic equipment
regulations 2013 (as amended)" and in
accordance with national regulations,
electrical equipment that has reached
the end of its product life must be
collected separately and recycled in an
ecologically compatible way. If electrical
equipment is disposed of in dumps
or in landfills, hazardous substances
can leak into the groundwater and
contaminate the food chain, damaging
your health and well-being. For further
information on the disposal of this
product, contact your dealer or a
domestic waste collection service.
Separate waste collection of the
products
allows the materials to be recycled
and
materials help to prevent environmental
pollution and reduces the demand for
raw materials.
.
3. SAFETY SIGNS
Various symbols appear on the battery and charger.
Meaning of the symbols:
Read the instructions
before charging.
Class II
Dual insulation
For indoor use only
with domestic waste.
of European
and packaging
reused. Reuse of
T2A
IMPORTANT Any damaged or illegible decals must be
replaced. Order replacement decals from an authorised
service centre.
4. CHARGING PROCEDURE
In
1. Connect the charger (3) to an AC outlet (1).
Directive
2. Put the battery pack (2) into the charger (3).
3. The LED charger lights (4) and LED battery lights (5) will
light in a specific order to communicate the current battery
status.
used
1
recycled
EN - 2
Fuse
conformity marking
Do not dispose of this product
with domestic waste.
Output polarity
CG 20 Li
3
1
CGD 20 Li
3
2
5
4
2
5
4
4