Audibax ADP 24 DSP Manual De Usuario página 10

Output channel configuration:
The output configuration keys (Fig 8), depending on the model (ADP24DSP from 1 to 4)
(ADP36DSP from 1 to 6) (ADP48DSP from 1 to 8) have 2 types of keystrokes:
1) Brief press activates or deactivates the MUTE function, when MUTE is activated the red
LED at the top of the button remains on, another brief press will turn off said LED and the
channel will remain open.
2) Long press (more than 2 sec) enters the channel configuration mode, The unit has a set
of keys to navigate and vary functions within its setting, (fig3) press BACK, to return to the
previous menu, press NEXT to advance to the next menu, press ENTER to select a menu,
turn the Freq wheel (fig4) to cycle through the menu options, Turn the Gain/Q wheel(s)
(fig5) to vary the values (both wheels have the same function)
Press ESC to exit to the main menu
Press SYSTEM to enter the unit configuration menu.
1. Gain and output routing configuration, press the key of the output channel to be
adjusted for 2 seconds, the interface will display this menu:
The gain adjustment levels are designated in a range of -48dB to +12dB, Turn the FREQ
wheel to select the Gain section, turn the GAIN or Q wheel/s to increase or decrease the
values.
Routing, Turn. the FREQ wheel to access the source selection (A,B,C,Ddepending on
version) the route options vary between ON/OFF, ON the selected source is activated, OFF
the selected source is off, you can route as many sources as exit. as required or available
on each channel (depending on model).
2 Output polarity, Press NEXT to enter polarity adjustment, the interface will display the
The polarity of each output channel can be adjusted independently, by default the unit
sends it in "normal" format to invert the polarity (180º). Turn the FREQ Wheel, you can
alternate between "Normal" (0º) or "invert" (180º). Or rotate FREQ/GAIN/Q to adjust the
polarity.
Each channel has an independent delay control, by default the unit is set in Meters
Seconds plus, with a range of 0 to 1000ms. Turn the FREQ wheel to increase or decrease
the range.
4. Crossover (frequency divider) adjustment Press NEXT to and the interface will display
the following message4. Press the Next button to enter the frequency division setting
Out1
25Hz
www.audibax.com
ADP 24 DSP / ADP 36 DSP / ADP 48 DSP
Out1 Gain: 3.0dB
A: ON B: OF C: OF D: OF
Out1 Polarity
Pol=Invert
Out1
x10.0 Dly=178.992ms
Hpf
Bessel 24
8
Delay
Out1
Bessel 24
20000Hz
Lpf