AERMEC MODUCONTROL Manual De Uso página 55

Code
Alarm code
Pre-alarm
Gas high temperature alarm pressing line
93 193
Pressure differential lower than that
94 194
95 195 Compressor start-up failed (uPC)
Time exceeding operational limits alarm
96 196
97 197 Super Heat low alarm (uPC)
98 198
99 199 Low intake temperature alarm (uPC)
200 300 EVD EVO alarm: Evotunes alarm (uPC)
201 301 EVD EVO regulation alarm (uPC)
EVD EVO system alarms probe errors alarm
202 302
203 303
No communication between inverter and
204 304
Inverter not compatible with the
205 305
compressor selected (uPC)
Delta P greater than the permit at start
206 306
207 307
ATTENTION: Please Note that the pre-alarms are automatic reset, while the alarms are manual rearmament.
The 3.9.0 software version has been introduced to reset the alarms via the ON/OFF remote contact if enabled. From on position, if it switches to off and returns to on within 5
seconds resets the alarms; The ON/OFF contact can be performed at maximum 3 reset every hour.
First you have to reset the alarms with "R" key.
In case of power failure the alarms are reset.
Causes
Control wiring
(uPC)
Control wiring
specified (uPC)
Control wiring
Control wiring
(uPC)
Control wiring
MOP alarm (uPC) Control wiring
Control wiring
Control wiring
Control wiring
Control wiring
(uPC)
Reserved (uPC) Control wiring
Control wiring
uPC. (uPC error)
Control wiring
Control wiring
up (uPC)
Low pressure limit Discharged unit
Note
55