Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the water inlet hose onto the water tap properly.
For normal washing machine operation, the pressure in the water mains should be between
0.1-1 MPa (1-10 bar; 1-10 kp/cm
determined by measuring the water flow. In 15 seconds, 3 litres of water should flow from a fully
open tap.
Tighten the water supply hose by hand, firmly enough for the hose to have a good seal (max.
2 Nm). After connecting the hose, the seal must be checked for any leaks. Do not use pliers or
similar tools when connecting the hose as this could damage the nut thread.
Only use the water supply hose supplied with the appliance. Do not use any used or other hoses.
Make sure the hose is not damaged. If the hose is degraded, brittle, or cracked, it has to be
replaced.
If an internal tube or hose is damaged, a shut-off system is activated that cuts the water supply to
the washing machine. In such case, the control glass (a) will turn red. Replace the water supply
hose.
; 10-100 N/cm
). Minimum dynamic water pressure can be
2
2
AquaStop
Regular
Connection
19
Publicidad
