Publicidad
Idiomas disponibles
Idiomas disponibles
How to Install Your Canopy Housing
NOTE: This step is applicable after the necessary
wiring is completed.
1.
Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)
How to Assemble Your Ceiling Fan Blades
1.
Secure the three blades using the 1/4˝-20 screws
and blade plate assembly through the holes located
on the bottom of the motor housing assembly.
(Figure 1)
NOTE: You will find the fan blade set packed in its
own carton and hardware bag in the fan box.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
2.
Position the trim cover onto the blade plate
assembly bottom. (Figure 2)
NOTE: Trim cover is included with the blade set,
not with the fan.
Motor Housing
Assembly
Blade Plate
Assembly
1/4˝-20
Screws
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
1/4˝-20 Screw
(2 each per blade)
Figure 1
HARDWARE USED:
Blade Plate Assembly
Trim Cover
(not included)
Figure 2
Blade
(not included)
X 6
Publicidad
