Garland MULE 561 E-V20 Manual De Instrucciones página 28

English
6. START UP INSTRUCTIONS
6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Motor set
• "U" shaped tube
• Upper handlebar
• M5 screw (x2)
• M6 screw (x4)
• Wing nut (x4)
• Clip (x1)
• Cable extension clamp (x1)
• Manual
6.2. MOUNTING
6.2.1. INSTALACIÓN DEL MANILLAR
1. Insert the extension cable clamp (3) into the "U"
shaped tube
2. Align the tube in a "U" shape to the two lower
tubes of the machine. Insert the screws (4) through
the holes in the tubes. Screw the 2 wing nuts (5)
onto the screws (4).
3. Align the upper handlebar to the "U" shaped tube
using the 2 screws (4). Screw the 2 wing nuts (5)
onto the screws.
4. Secure the cable with the clip (6).
6.2.2. INSTALLING THE WHEELS
Insert the wheels on the axle, then attach the
washers, tighten the screws and finally put the caps
on.
To lower the wheel frame, press the lock button on the
rear of the motor housing (Step A). Lower the wheel
frame (step B) and remove the locking pin (step C).
Align the locking pin with the hole and then release it
to lock the wheel frame in position.
28/112