Garland MULE 561 E-V20 Manual De Instrucciones página 29

6.3. CHECKING POINTS PRIOR TO USING THE
MACHINE
The current and tension supplied must coincide with
those in the characteristics label. Prior to starting
work check that the machine works adequately and all
security measures work.
Check the machine and look for any loose pieces
(screws, nuts, housing etc) and for any damages.
Tighten, repair or replace those pieces that you have
found to be in a bad state. Ensure that there are no
leakages. Do not use the machine if damaged or not
well regulated.
6.3.1. FIXING CABLE EXTENSION
Only use cable extensions that are homologated for
outdoor use. The cable section must be at least 1.5
mm and the cable extension should never be longer
2
than 25 m and must be completely unrolled before
starting to work.
Fix the extension of the tiller by
inserting cable in the hook on the
handle and plug onto the machine.
6.4. START UP AND STOPPAGE
Turning on the machine:
Press the safety button (A) and, without releasing it,
pull the switch
lever (B) towards
the handlebar.
Then stop
pressing the
A
safety button (A).
Disconnecting the machine:
Release switch lever (B).
6.5. TRANSPORT WHEELS
wheels must be in the working position.
To place the wheels in the working position, pull the
ring, unlocking the wheel clamp, and raise them until
they are fixed with the button.
To return the wheels to the transport position, release
the wheels by pressing the button and lower them
until they are locked with the ring.
Transport position:
Ring for securing the
transport wheels
6.6. OVERLOAD PROTECTION
This tiller has a security switch that will disconnect
the machine under the following conditions:
• If too much material accumulates on the blades.
• If the material being worked on is too resistant for
B
• If the machine detects a high level of resistance on
If you detect that the machine does not start when
the switch is on the On position, the probable cause
will be that the security switch is activated. In this
case disconnect the machine from the mains, check
that the blades are clean and have no elements that
29/112
Attention: To work with the tiller, the transport
Button
the engine capacity.
the blades.
English