Descargar Imprimir esta página

KitchenAid ARTISAN 5KES100BPM0 Guía Para Conseguir Resultados Profesionales página 26

Cafetera exprés

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 85
7. Press the "
" Button – it is not necessary to wait for
the boiler to heat. This activates the water pump and
fills the brewing boiler with water. After a few seconds,
water will flow from the brew head. When the cup is
full, press the "
" Button again to stop the water
pump. The brewing boiler is now ready for use.
8. Place the frothing jug under the nozzle of the
frothing arm.
For the finest results when brewing espresso, see pages
12–15.
1. Make certain the water tank has an adequate supply of
water (the water level should be between the "max"
and "min" fill lines).
2. Select the small or large capacity filter basket. Use the
small capacity basket for one cup (30 ml) of espresso,
and the large capacity basket for two cups (60 ml).
The small capacity basket can be used with paper
coffee pods.
3. Press the filter basket into the filter holder until it
snaps into place. Do not fill the filter holder with
coffee at this time.
4. Position the filter holder underneath the brew head and
align the filter holder handle with the "
side of the metal trim ring. Raise the filter holder into
the brew head, then move the filter holder handle to
the right so that it aligns with the "
trim ring.
5. Press the "
" Button to turn the espresso machine on.
Preparing the Espresso Machine for Use
Brewing Espresso
" on the left
" on the metal
9. Slowly open the "
" Dial by turning it counter-
clockwise, then press and hold the "
activates the water pump and fills the frothing boiler
with water. After a few seconds, water will start flowing
from the nozzle.
10. When the jug is about half full, release the "
and close the "
" Dial by rotating it clockwise until it
stops. The frothing boiler is now ready for use.
11. If no espresso is desired at this time, press the "
Button to turn the espresso machine off.
NOTE: Do not press the "
water in the tank. Damage to the water pump may occur.
Start
6. Wait until the espresso machine has reached operating
temperature; this will take approximately 6 minutes.
7
" Button. This
" Button
"
" or "
" Buttons without
Finish

Publicidad

loading

Este manual también es adecuado para:

Artisan 5kes100