ADInstruments AD71B Manual De Usuario página 46

_____________________________________________________________________
Testing resistance signal from
calibrator:
When testing resistance signal from
calibrator, it is necessary to press this
button to change the maximum display
to 4000 counts but the accuracy
remains unchanged.
Setup feature:
Access Setup selections, the display
shows "SET".
In the Setup mode, each press of
SETUP button steps to the next
Selection
Press to output the data, AUTO mode
switch off. The primary display shows
"SEND".
(UT71A
Press EXIT to exit.
only)
Setup feature:
In Setup, press to select OFF at the
selection of HIGH and LOW
Store feature:
Store the current measurement value.
Press EXIT to exit the Store feature.
Recall feature:
Recall the stored value. Press EXIT to
exit the Recall feature.
(UT71B
only) Setup feature:
In Setup, press to select OFF at the
selection of HIGH and LOW
Hold feature:
Press HOLD to freeze the displayed
value. Press EXIT to release the
display.
Peak Hold feature:
Press to access Peak Hold feature, the
primary display shows PEAK HOLD.
Press EXIT to exit.
©Copyright Abacanto Digital SA.
Manual de usuario AD71B
AD Instruments
Press and hold
the button while
turning on the
Meter
Press and hold
the button for
more than 1
second
Press the button
once.
Press the button
once after
entering Setup
mode.
Press the button
once.
Press and hold
the button for
over 1 second
Press the button
once after
entering Setup
mode.
Press the button
once.
Press and hold
the button for
over 1 second.
46