Changing The Default Setting; Introduction; Selecting Setup Options - ADInstruments AD71B Manual De Usuario

_____________________________________________________________________

Introduction

The Meter allows you to change the default operating configuration of the Meter by
changing setup options made at the factory.
These settings are stored and can be changed in the Setup mode using the procedure
described in this chapter.

Selecting Setup Options

To enter the Setup mode, turn the Meter on and press and hold SETUP button for over
1 second. It is recommended to change the default setting only when the Meter is at
DCV measurement mode.
In the Setup mode, each press of SETUP button steps to the next Selection. Each
press of – or + button decrement or increment an Option.
Each Setup Selection and Option appears in the primary display in the sequence shown
in Table 5-1.
Selec
tion
HIGH Max. 40000
Press to select OFF
Press to select the digit you
want to edit
LOW Max. –40000
Press to select OFF
Press to select the digit you
want to edit
10
20
30
OFF
S1
OFF
10
20
30
©Copyright Abacanto Digital SA.

Changing the Default Setting

Table 5-1. Setup Selections
Option
Manual de usuario AD71B
Factory
Default
OFF Over the upper limits, beeps
not continuously.
OFF Over the lower limits, beeps
not continuously.
10 mins power off
20 mins power off
10 mins
30 mins power off
Power off feature is disabled
Beeps continuously and icon
S1 lights on
No beep, icon flashes
Backlight turn off in 10
seconds
Backlight turn off in 20
10
seconds
Backlight turn off in 30
seconds
AD Instruments
Chapter 5
Description
63