Secure The Drain Hose; Level The Washer; Important - Maytag MHN30PD Instrucciones De Instalación

2. Slide drain hose onto washer connection.
3. Once drain hose is in place, release pliers.
Washer drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
To keep drain water from going back into the washer:
Use the drain hose form, and do not force excess drain hose
■
into standpipe. Hose should be secure, but loose enough to
provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
■
Floor drain
You may need additional parts. See Floor drain under "Tools
and Parts."

Secure the Drain Hose

Drain hose must be secured to stop the hose from moving when
water is pumped out. If the drain hose moves, water may end up
on the floor.
1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose in the laundry tub or standpipe as shown.
See illustrations A and B.
114 mm
114 mm
(4 / ")
1
(4 / ") 2
1
2
A
NOTES:
Do not force excess drain hose back into the rear of the
■
washer.
To avoid siphoning, do not seal or put more than
■
114 mm (4½") of the drain hose into drainpipe or standpipe.
If the washer faucets and the drain standpipe are recessed,
■
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.

Level the Washer

Properly leveling your washer avoids excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
2. Make sure all four feet are stable and resting on the floor. Then
check that the washer is perfectly level (use a level).
3. After the washer is level, use a 9/16" open-end wrench to turn
the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the washer may vibrate.
4. The washer should not move front to back, side to side,
or diagonally when pushed on its top edges.
5. Slide the washer to its final location.
6. Confirm the levelness of the washer.
114 mm
B C
(4 ")
1 /
2
9