Rane TWELVE Guia Del Usuario página 7

6. 33 & 45 RPM: Press one of these buttons to set the rotation speed (RPM) of the platter.
The lit button indicates the current selection.
7. Pitch Range: Press one of these buttons to adjust the range of the Pitch Fader to ±8%,
±16%, and ±50%.
8. Pitch Fader: Move this fader to adjust the speed (pitch) of the track. You can adjust its
total range with the Pitch Range buttons.
9. Takeover LEDs: When you select another Deck with the Deck Select buttons, the
position of the Twelve's Pitch Fader may not match the Pitch setting for that Deck in the
software. Slowly move the Pitch Fader in the direction indicated by the Takeover LED
arrow until it turns off. At this point, the Pitch Fader matches the Pitch setting in the
software and can control it again.
10. Touch Strip: This pressure sensitive strip replaces the tone arm and allows the user to set
track position depending on the Touch Strip Mode setting.
11. Touch Strip Mode: Press this button to toggle the Touch Strip between Needle Drop and
Hot Cue modes. When Needle Drop is selected (default when Twelve is powered on), the
button will be dimly lit. When Hot Cue is selected, the button will be brightly lit.
• Needle Drop Mode
i. Press the Cue Mode button so it is dimly lit. (This is the default mode when Twelve
is first powered on.)
ii. The length of the Touch Strip represents the length of the entire track. Place your
finger on a point along this sensor to jump to that point in the track. White LEDs on
the Touch Strip will give a visual representation of the position of the needle in the
track.
• Hot Cue Mode
i. Press the Cue Mode button so it is brightly lit.
ii. When a section of the Touch Strip is unlit, you can assign a Hot Cue Point by
pressing it at the desired point in your track. Once it is assigned, the section will
light. The software determines the color of the Hot Cue Point.
iii. While the track is playing, press the Hot Cue Point to return the track to that point.
iv. To delete a Hot Cue Point, press and hold the Cue Mode button and press the
section you would like to delete.
12. Deck Select: Selects which deck in the software is controlled by Twelve. Up to four
Twelve controllers can be connected with a Serato DJ Pro-enabled device provided the
device has enough channels. For instance, if you are using a two-channel mixer such as
the Rane Seventy-Two, only up to two Twelve controllers can be connected and only the
first 2 channels will be available for selection. When you are using more than one Twelve
controller at a time, you will need to determine which deck each controller is assigned to:
i. Power on each controller. The available Deck Select buttons on all connected
Twelve controllers will flash.
ii. Press the Deck Select button that corresponds to which deck you would like to
assign each Twelve to. Once a Deck is selected and in use, the button LED will be
fully lit, and buttons for other available decks will enter a dim state.
iii. To switch to another available deck, press the corresponding Deck Select button.
iv. To unselect a deck, press and hold the corresponding Deck Select button for 2
seconds. When buttons for the available decks start flashing, you are ready to select
a new deck.
7