Panasonic EY46A2 Manual De Instrucciones página 9

the line of cut and near the edge of
the workpiece on both sides of the
wheel.
6) Use extra caution when making a
"pocket cut" into existing walls or
other blind areas. The protruding
wheel may cut gas or water pipes,
electrical wiring or objects that can
cause kickback.
Symbol
V
n
Revolutions or reciproca-
... min
-1
Ah
injury, user must read and
understand instruction
Always wear eye protec-
WARNING
• Do not use other than the Panasonic
battery packs that are designed for
use with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the
use of the recycled battery pack and
the counterfeit battery pack.
• Do not dispose of the battery pack in
a fire, or expose it to excessive heat.
• Do not drive the likes of nails
into the battery pack, subject it to
shocks, dismantle it, or attempt to
modify it.
• Do not allow metal objects to touch
the battery pack terminals.
• Do not carry or store the battery
pack in the same container as nails
or similar metal objects.
• Do not charge the battery pack in a
high-temperature location, such as
next to a fire or in direct sunlight.
01_Eng_EY46A2(EU).indd 9
Meaning
Volts
Direct current
Rated speed
tions per minutes
Electrical capacity of
battery pack
To reduce the risk of
manual.
For indoor use only.
tion
- 9 -
Otherwise, the battery may overheat,
catch fire, or explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack
from the tool or the charger, always
reattach the pack cover. Otherwise,
the battery contacts could be
shorted, leading to a risk of fire.
• When the Battery Pack Has
Deteriorated, Replace It with a New
One. Continued use of a damaged
battery pack may result in heat
generation, ignition or battery
rupture.
III. ASSEMBLY
NOTE:
When attaching or removing a support
handle, disconnect battery pack from
tool.
CAUTION
Always be sure that the support handle is
installed securely before operation.
• Screw the side handle securely as
shown in the figure.
CAUTION:
Never actuate the lock pin when the
spindle is rotating. The tool may be da-
maged.
• Press the lock button to prevent spindle
rotation when installing or removing
parts, such as grinding disc, disc guard,
etc.
2014/07/02 12:01:16