Variable Speed Switch - DeWalt DCH363 Manual De Instrucciones

2.Rotate t he side handle tothe desired position.
3.Tighten theside handle b yturning i tclockwise until youaresure
theside handle won't s lip.
TO CHANGE SIDES
For right-hand users: slide the side handle clamp over the chuck,
handle at the left.
For left-hand users: slide the side handle clamp over the chuck,
handle at the right.
Depth Rod (Fig. 2)
To adjust the depth rod (F), loosen the side handle (A) and move the
depth rod so that the distance between the end of the rod and the
end of the bit equals the desired drilling depth. When drilling with
depth rod, stop when end of rod reaches surface of material.
Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (B). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake. The
chuck will stop as soon as the trigger switch is fully released.
VARIABLE SPEED SWITCH
The variable speed switch enables you to select the best speed for a
particular application. The farther you squeeze the trigger, the faster
the tool will operate. For maximum tool life, use variable speed only
for starting holes or fasteners.
NOTE" Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Mode Selector (Fig. 2)
i_CAUTION: Never change the mode while the unit is running.
For straight drilling, rotate the mode selector (D) until the arrow points
to the drill bit symbol (H). For rotary hammer, align the arrow with the
hammer symbol (I). For chipping mode align arrow with the chipping
symbol (J).
NOTE" The mode selector (D) must be in drill, hammer or chipping
mode at all times. There are no operable positions in between.
Forward/Reverse Control Button
(Fig. 1, 3)
A forward/reverse control button (C) determines the direction and also
serves as a lock-off button.
To select forward rotation, release the trigger switch (B) and
depress the forward/reverse control button on the right side of thetool.
To select reverse, depress the forward/reverse control button on the
left side of the tool.
The center position of the control button locks the tool in the
off position. When changing the position of the control button, be
sure the trigger is released.
NOTE" The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
FIG. 3
C
UNLOCKED, LOCKED UNLOCKED,
FORWARD REVERSE
10