Makita TW0200 Manual De Instrucciones página 5

Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the socket.
1
2
003998
Align the hole in the side of the socket with the detent pin
on the anvil and push it onto the anvil of the tool until it
locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Installing and removing hook
1
004000
Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal
procedure in reverse.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
1. Socket
2. Anvil
1. Hook
5
Standard bolt
200
180 M16X80
(5/8"X3-1/8")
160
140
120
100
M12X80
80
(1/2"X3-1/8")
60
M10X80
40
(5/16"X3-1/8")
20
0
1 2
Fastening time (S)
004236
High tensile bolt
200
M12X80
180
(1/2"X3-1/8")
160
140
M10X80
120 (3/8"X3-1/8")
100
80
60
40
20
0
1 2 3
Fastening time (S)
004237
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
NOTE:
When fastening screw M10 (3/8") or smaller,
•
carefully adjust pressure on the switch so that the
screw is not damaged.
Hold the tool pointed straight at the bolt or nut
•
without applying excessive pressure on the tool.
If you fasten the bolt for a time longer than shown in
•
the figures, the bolt or the socket may be
overstressed, damaged, etc. Before starting your
job, always perform a test operation to determine
the proper fastening time for your bolt. Especially
for the bolt over than M10 (3/8"), perform the above
test operation to prevent the trouble on socket or
bolt, etc.
M16
(5/8")
M12
(1/2")
M10
(3/8")
4
3
M12
(1/2")
M10
(3/8")
4 5