Publicidad
Idiomas disponibles
Idiomas disponibles
upper or the upper and lower elements
may be selected.
∙ The switch settings (upper heat/lower
heat) may be changed during the cooking
process.
∙ After the pre-programmed cooking time
has elapsed, the timer will automatically
switch off the heating elements.
∙ To switch off the appliance earlier, set the
timer to '
'.
∙ Always use the door handle to open
the hot door after use. When removing
the baking tray or rack, use the handle
provided. Likewise, when removing the
spit, the spit handle must be used. Always
place the baking tray and rack on a heat-
resistant surface.
∙ Remove the plug from the wall socket
after use.
Cooking times
The grilling/cooking times listed are
approximate times only, as each food to
be grilled or cooked is of a different nature
and consistency; please also refer to the
information contained on the food packaging.
Temperature
Food
Chicken
(rotating spit)
Pizza (deep-
frozen)
Toast Hawaii
Baguette
(deep-frozen)
14
Grilling/
cooking
/ setting
time
180°C
60
mins.
200°C
9-10
mins.
220°C
10-14
mins.
200°C
14-15
mins.
Cleaning and care
∙ Before cleaning the appliance, ensure it is
disconnected from the power supply and
has completely cooled down.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ Do not use abrasives, harsh cleaning
solutions or spray-type oven cleaners.
∙ The exterior of the housing may be
cleaned with a damp, lint-free cloth.
∙ After cooking a chicken, ensure that any
fat that may have dripped onto the lower
heating elements is completely removed
using a damp cloth.
∙ The baking tray, baking rack, spit and
holding clamps may be cleaned using
hot water and a mild detergent, or in a
dish-washer.
∙ The crumb tray may be taken out for
cleaning. Any large accumulation of fat
in the tray should fi rst be cleaned up with
a paper towel. Make sure that the tray
is refi tted in its proper position under the
heating elements.
∙ The inner glass plate of the door may
also be removed for cleaning. Open the
door to the horizontal, loosen the screw
and pull the glass plate out, cleaning
and drying it thoroughly afterwards. To
replace, fi t it between the guide slots in
the glass door, ensuring that it is properly
located above the centre guide slots and
below the two outer slots. When the plate
is replaced, ensure it is the right way up
– ie the open side of the rubber seal (with
the fl ap) downwards against the fi xed
glass plate. Retighten the screw.
Publicidad
