Drilling diameter range in metal (solid-head drill bit)
Drilling diameter range in metal (solid-head drill bit)
5 Operation
Removing the battery
Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the
clamping band is engaged in the groove provided on the tool.
CAUTION
Risk of injury The depth gauge may hinder the operator if fitted but not used.
▶ Remove the depth gauge from the tool.
Fitting / removing the chuck
CAUTION
Risk of injury The depth gauge may hinder the operator if fitted but not used.
▶ Remove the depth gauge from the tool.
Fitting the chisel
Note
The use of unsuitable grease may cause damage to the tool. Use only the
recommended grease supplied by Hilti.
Note
After fitting the drill bit, grip it and pull it in order to check that it is securely engaged.
Removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly inflammable mate-
rials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
Fitting and adjusting the depth gauge
Forward / reverse
CAUTION
Risk of damage Actuation while the tool is running may result in damage to the gearing.
▶ Do not operate the forward / reverse switch while the motor is running.
Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the combihammer.
▶ Before fitting the battery, check that the combihammer is switched off and that the
forward / reverse switch is in the middle position (i.e. safety lock engaged).
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts
on the combihammer are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the
battery is securely seated in the combihammer.
6
TE 30A36
1/8 in ... 1/2 in
3 mm ... 13 mm
3
4
5
6
7
8
9
11