Helios Gamma Manual Del Usuario página 28

GRAPH HIGH
GRAPH LOW
AUTOPRINT
When ON, results are printed automatically after each run.
Before attempting to print at any point during operation of the instrument ensure that
the printer is ready to print, ie switched on, on line and supplied with paper. Failure to
do so will result in an error condition. Press CLEAR to clear the error message ( the
system may take a little time to respond ). Ensure the printer is ready and retry.
CELL PROG
REF MODE
SCAN PARAMETERS page function keys
* SCAN *
GD Issue 1 (08/2000)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SCAN
: Select from range (GRAPH LOW + 0.01) to 6.00.
Sets the upper graph limits on the SCAN GRAPH page.
GRAPH HIGH must be 0.01 greater than GRAPH LOW.
: Select from range -0.3 to (GRAPH HIGH- 0.01).
Sets the lower graph limits on the SCAN GRAPH page.
GRAPH LOW must be 0.01 less than GRAPH HIGH.
: Toggles between ON and OFF.
: Appears when the Cell Programmer is fitted. Switches to
the CELL PROG screen.
: Appears when the Cell Programmer is fitted. Toggles the
status of the Cell Programmer reference mode.
VIEW RESULTS - Switches to the Scan Peak Table
screen if any of the peak functions have been
performed or the Track Table screen if track has been
used.
VIEW GRAPH - Switches to the Scan Graph screen.
SAVE METHOD - Brings up the Filename Function
screen and then saves the method including ID and
track wavelengths if the PEAK TABLE parameter is set
to TRACK.
MENU – Switches to the MENU page.
English 23