Tyre Changing - Vermeiren Carpo 3 Manual De Instrucciones

ARMRESTS
The width of the seat can be changed by adjusting the arm rests.

Loosen the screws under the seat.

Now pull or push the entire arm rests to the desired position.

Properly tighten the screws again.
The arm pads can be folded backward.

TYRE CHANGING

L
CAUTION: There must be no air in the tube before it can be removed.
L
CAUTION: Risk of damage - If handled improperly, the rim might be damaged.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. No liability is accepted for damage caused by non-
genuine replacement parts. Kindly contact your specialist dealer.
Assembly:
L
WARNING: Risk of injury - Check that the pressure is correct.
L
CAUTION: Risk of injury - Make sure that no objects or body parts are pinched between the
tyre and the rim when mounting a tyre.
L
WARNING: Risk of injury - Make sure all screws are firmly secured by hand before driving
with your scooter. Screw adhesive (ex. Loctite) should be applied to the screws on the
flange. Screw adhesive will only work if the thread is free of grease and particles.
Instruction manual Carpo 3 / Carpo 4
G
L
Do not pull out the arm rests so far
that there will remain insufficient
space to retighten the screws.
H
L
Never perform adjustments while you
are driving.
Last updated: 2018-07
6