Operating The Plasma Display; Mode - FUNAI F42PDME Manual Del Usuario

OPERATING THE PLASMA DISPLAY
SCREEN MODE _,HH,,,
POWER
, i
_IUT£
0
INPUT SELEOT
0
[_ISPLAY
0
By changing the aspect ratio of the screen you
can select the manner in which you wish to view
the picture.
1
Press the SCREEN MODE button to display
the current screen mode.
2 Press the SCREEN MODE button a second
time to change the screen mode.
Each time you change the screen mode, the
name of the selected mode is displayed on the
screen for approximately 4 seconds.
The SCREEN MODE button switches between
the screen modes in the following pattern.
NOTE:
• When switching the input signal, the audio mute
turns ON temporarily.
• You can only select the "Normal" and "Zoom"
screen modes for 1080i and 720p video signals
connected to the COMPONENT 2 terminal.
Mode Picture Explanation
Normal
Full
Wide
Zoom
Normal will display a 4:3 picture at its standard 4:3
size. For 1080i and 720p video signals, a picture will
be displayed at 16:9 size.
Full will display a 4:3 picture at a 16:9 size, with
horizontal elongation necessary to fill the screen.
Wide will display a 4:3 picture at a 16:9 size, with less
horizontal elongation necessary to fill the screen
because a little bit of the top and bottom will be cut off.
Zoom will magnify the entire 4:3 picture to fill the
screen, with no horizontal elongation to fill the screen,
as more of the top and bottom are cut off. Use this
mode to view letterboxed 4:3 picture content to get a
widescreen picture. A 16:9 picture will be magnified
similarly, but to a lesser extent.