Changing The Battery In The Remote Control - Dometic PERFECTWALL PW3500 Instrucciones De Uso

Operating the awning
➤ Move the front cover (fig. 4 1, page 2) for about 8 seconds approx. 75 to
100 mm repeatedly back and forth to simulate vibrations from the wind.
✓ The awning retracts automatically all the way.
If the awning does not retract automatically
➤ Check the battery status of the wind sensor and replace if necessary, see chapter
"Changing the batteries in the wind sensor" on page 15.
➤ Test the wind sensor again.
➤ If the wind sensor does not work and the awning does not retract automatically,
reprogram it, see chapter "Reprogramming the wind sensor" on page 17.
➤ Test the wind sensor again.
➤ If the wind sensor does not work after reprogramming, contact your service
partner.
6.5

Changing the battery in the remote control

I
NOTE
If the LED in the remote control does not light up after pressing one of
the buttons, the remote control battery is flat.
➤ Open the housing of the remote control (fig. 3 1, page 2).
➤ Remove the old battery from the holder.
➤ Insert the new CR2450 (3 V) battery type into the holder with the positive
terminal facing upwards.
➤ Reassemble the remote control.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
14
PW3500
EN