Storing The Machine; Replacing Nylon Line - Stihl FS 75 Manual De Instrucciones

English / USA

Storing the Machine

For periods of about 3 months or longer
:
Drain and clean the fuel tank in a
well ventilated area.
:
Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
: Remove, clean and inspect the
cutting tool.
: Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
:
Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
:
Dispose of remaining fuel and
cleaning solution properly in
accordance with local
environmental requirements.
30

Replacing Nylon Line

STIHL AutoCut 11-2
Always inspect the mowing head for
signs of wear before replacing the nylon
line.
If there are signs of severe wear, it
may be necessary to replace some
parts or thecomplete mowing head.
Preparations
:
Shut off the engine.
:
Lay your brushcutter on its back
with the mowing head facing up.
1
2
Removing Remaining Nylon Line
:
Open the mowing head. To do this,
Hold the mowing head steady and
rotate the cap (1) counterclockwise.
:
Disengage the spool (2), take it out
of the mowing head and remove the
remaining line.
Winding Line onto Spool
A prewound spool** may be
installed to save the following
procedure.
** see "Special Accessories"
FS 75