Toyotomi TD-C1410 Manual De Instrucciones página 5

3. OPERATING INSTRUCTIONS
1. The Power indication light will turn on when the unit is plugged
in, regardless of whether the unit is operating or not.
2. Press button once to start operation. Press it again to stop
operation.
3. Press button as follows:
Press to set the desired fan speed. It can be adjusted between
high speed and low speed.
4. Press button to set the desired humidity level in the room, which
can be set from 40% to 80% at 5% intervals.
After a period of working, when environment humidity is lower
than the selected humidity by 2%, compressor will stop and fan
stops working 3 mintues later; When environment humidity is
equel to or higher than the selected humidity by 2%, compres-
sor will restart once 3-minute compressor protection time over.
5. Press button can be timer setting:
Press the adjustment button to program the time when the unit
turns on and turns off. If you want to cancel the timer program-
ming, press the button to adjust the time at 00, and press the
button, it will be circulate from 00-01-02......23-24. It is the pro-
grammed time to switch the machine. The programmed time will
be cancelled when to switch compressor manually each time.
The programmed time remains unchanged if the machine stops
to wok due to water full or during defrosting.
4. DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn
on, the operation will stop automatically and the buzzer will beep
15 times to alert the user, that the water need to be emptied from
the drainage tank.
5. EMPTYING THE DRAINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull
the tank out gently.
2. Discard the collected water.
NOTE
1. Do not remove the float from the
water tank. The water full sensor
will no longer be able to detect the
water level correctly without the
float and water may leak from the
water tank.
2. If the drainage tank is dirty, wash it with cold or lukewarm water.
Do not use detergent, scouring pads, chemically treated dust
cloths, gasoline, benzene, thinner, or other solvents, as these
can scratch and damage the tank and cause water leakage.
3. When replacing the drainage tank, press the tank firmly into
place with both hands. If the tank is not positioned properly, the
"TANK FULL" sensor will be activated, and the dehumidifier will
not operate.
6. CONTINUOUS WATER DRAINAGE
The unit features a continuous drainage port. Using a plastic pipe
(with an inner diameter of 10mm) inserts into drain hole (on inter-
mediate plate), reach out from side of water tank, install it in place,
and arrange the drain pipe.
The water in the drainage tank can be continuously drained out
from the continuous port on the unit.
4
ENGLISH