Troubleshooting - Silhouette DKC055D1SSPRO Manual Del Propietário

TROUBLESHOOTING

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
No power
Internal temperature not cold
enough
Appliance runs continuously
Alarm sounding and "HI" on
the display panel
Alarm sounding and "LO" or
"CL" on the display panel
Excessive beer foam
Weak beer fl ow
Silhouette Consumer Care: 1-844-455-6097
• A fuse may be blown or the circuit breaker tripped
• Plug not fully inserted into the wall outlet
• Door is not shut properly or opened excessively
• Exhaust vent is obstructed
• Ambient temperature or humidity is very high
• Possible system leak, evaporator fan failure or compressor failure
• Ambient temperature is excessively low
• Sensor failure
• Ensure the beer line hose from the tower and the CO
from the CO regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
hole in it
• The CO pressure may be set too high; try turning the pressure down
2
• Ensure that the valve spool plastic rod is inserted into the coupler
• Ensure the beer line hose from the tower and the CO
from the CO regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
hole in it
• The CO pressure may be set too low; try turning the pressure up
2
• Ensure there are no bends or kinks in any of the hoses that could
impede fl ow
13
POSSIBLE CAUSE
connection at the coupler has a
2
connection at the coupler has a
2
air line hose
2
air line to the
2
air line hose
2
air line to the
2