INSTALLATION INSTRUCTIONS
PREPARING THE ENCLOSURE
Gloves and safety goggles should be worn during
installation.
If installing this appliance into an enclosure, ensure
that the casters, the guard rail and drip tray are not
installed on top of the appliance. These items will
create an obstacle for the enclosed installation.
The cabinet opening must be at least 24 inches (61
cm) wide by 35 inches (88.9 cm) high by 25 inches
(63.5 cm) deep.
It is not recommended to build the appliance into an
enclosure with the casters installed.
Note: The listed depth requirement is assuming
that the electrical outlet is located in the adjacent
cabinetry or fl ush mounted in the rear wall, not
surface mounted inside the enclosure.
If the electrical outlet is located inside adjacent
cabinetry, cut a 1.5 inch (3.8 cm) diameter hole to
admit the power cord. If the cabinet wall is metal,
the hole edge must be covered with a bushing or
grommet.
1.5 in (3.8 cm) diameter
35 - 40 in
(88.9 -
101.6 cm)
25 in
(63.5 cm)
*If electrical outlet in
adjacent cabinetry
2 in (5 cm)
Electrical Access
Electrical Access
6 in
(15.2 cm)
90°
24 in (61 cm)
REQUIRED TOOLS
• Safety goggles
• Gloves
• Tape measure
• Carpenter square
• Level
• Flashlight
• Electric drill with hole bit
COMPRESSOR COVER REMOVAL
If the appliance will be built into an enclosure, the
compressor housing cover must fi rst be removed.
This is to allow air fl ow around the compressor
so that it does not over heat. Keep the cover and
screws in a safe place so that they can be used
again in future if necessary.
ACCESSORIES
• The following accessories are included:
• 1 guard rail
• 1 drip tray
• 1 CO
regulator
2
• 1 CO
cylinder (empty)
2
• 1 CO
gas air line hose (colored)
2
• 1 beer line hose (clear)
• 1 beer keg coupler (American Sankey only)
• 1 faucet tower
• 1 pull handle (for beer tower faucet)
• 4 plastic plugs (for guard rail holes)
• 1 metal plate for cabinet bottom
• 1 steel clamp for colored hose
• 4 casters (2 with locks and 2 without)
• 4 leveling legs (pre-installed)
5