Folding Backrest; Manual Recline Operation; Swing-In/Swing-Out Footrests; Elevating Legrest - Zippie ZM-310 Manual De Instrucciones

Z I PP I E Z M- 3 10
I. FOLDING BACKREST
Zippie ZM-310 wheelchairs are shipped with backrest in folded position. (optional)
1. Upright Positioning
a. Lift backrest to upright position so that latch handles (A) lock into place.
b. Backrest is ready for use.

2. Folding Backrest

a. Lift and turn backrest latch handles (A) inward or outward.
b. Fold backrest forward.
Backrest latches must be locked into place before operating wheelchair.
J. MANUAL RECLINE OPERATION
The ASAP II seating system has two manual recline options.
1. Manual operation with wrench
a. Using a 16mm socket wrench at point (B) Rotate clockwise to recline, and counter-
clockwise to return the back to an upright position.
b. Backrest is ready for use.
2. Manual operation with recline knob
a. Using the manual recline knob (C) on the side of the chair, rotate clockwise to
recline, and counter-clockwise to return the back to an upright position
K. SWING-IN/OUT FOOTRESTS
Swing-in-Swing-out Hangers and Footrests are available in (80° & 90º)
1. Installation
a. From the side, place the pivot (F) into the top of the frame tube which guides the hanger into
the correct alignment with the locking plate (E) on front frame tube.
b. Rotate the hanger to the front until it locks into place on locking plate.
2. Removal
a. To remove footrest, release latch (D) by pulling lever upward or pushing lever downward.
b. Rotate footrest inward or outward and lift it out of the front frame tube.
L. ELEVATING LEGREST (Optional)
1. Installation
To install or remove Elevating Legrest (ELR) see instructions for Swing-away Footrest instal-
lation.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift slightly then press release lever (G)
down and lower legrest to desired position.
M. ANGLE ADJUSTABLE CENTER MOUNT FOOTREST
1. Quick Independent angle adjustment
a. Depress the button(H) and angle adjust the footplates as an assembly or indepen-
dantly of each other.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift slightly then press the button (H) and
lower legrest to desired position.
9
WARNING
10
11
12
13
17
VIII. USE & MAINTENANCE
HEADER
B
D
E
9
A
C
11
F
12
G
13
127899 Rev. B