Remote Control Description; Basic Operations; Switch On Stb - FTE univers U4128 Manual De Usuario

1 2 3
4
5
7
8 9
11
12
14
16
17
19 20 21

2.0. SWITCH ON STB

When the STB is fi rst used it will display the quick setup page where the receiver can be confi gured
quickly.
For further use the STB will play the same channel as last time when it was switched off.
? FREQUENTLY ASKED QUESTION
Q: The power of my STB is on and it is running in TV mode but the TV screen shows nothing:
A: Make sure the TV set has been set to the correct video input (not the TV channels). For example, if
you have connected the STB to the Video1 input of the TV set, then you need to select the corresponding
Input on the TV. Mostly it is done with the AV button of the TVs remote control unit.
Q: My STB is running in TV mode but the TV screen shows nothing except one ball and "No Signal".
A: That means the channel you selected has no signal. This can be caused by several reasons:
1. The channel you selected is not from the satellite to which your dish is pointing. Select another
channel.
2. The signal of current TV channel is too weak. You can try to change to other channels with a stronger
signal. If the problems still exist, please consult your local dealer or installer for technical service.
3. You selected the wrong LNB type in the installation menu or your DiSEqC switch confi guration is
not correct.
PANEL & REMOTE CONTROL DESCRIPTION
1. POWER: Switches receiver ON or in stand-by-mode.
2. TV/R: Switches between TV and Radio channels.
3. MUTE: Switches audio on and off.
4. NUMERIC KEYS: For direct typing values.
5. SAT: It shows the satellite list.
6. PAUSE: If you press it once, you will stop the image, and it
will come back to normal mode when you press it again.
7. Color Keys: Controls menu options.
8. EPG: Shows the EPG information.
6
9. AUDIO: Opens audio menu.
10
10. SUB: Switches subtitle on and off.
13
11. MENU: Opens the main menu.
12. ZOOM: Zoom function.
15
13. EXIT: Exit menus or stop operations.
14. OK: Confi rms selections or opens channel list.
15.
the cursor in menus.
18
16.
sor in menus.
17. PGUP / PGDN: Moves cursor in block steps.
18. TXT: Opens and closes teletext.
19. FAV: Opens favourite channel list.
20. RECALL: Watch the last viewed channel.
21. INFO: Shows channel information with signal bar.

2. BASIC OPERATIONS

PAG.
(CH+/CH-): Changes channels volume or controls
(V+/V-): Adjusts audio volume or controls the cur-
14