Powerspot Mini Thermix Instrucciones De Uso página 30

Mini Thermix can reach 20V over the
adequate flame, although the voltmeter
included can only indicate up to 17.3V.
With this tension the fan will release a
powerful heat air stream, but its life will
be severely shortened. If it is going to be
used as a heater, we suggest that it does
not surpass the 15V if you desire to fulfil
the 50,000 hours guaranteed by the
manufacturer.
Ideally, Mini Thermix provides two 9W
light points (1,600 lumens). However, it
can slightly light up at least ten points,
which is usually enough for a family
house. You must take into account that
every time you add a light bulb the
voltage will be reduced slightly, and
each light bulb will shine less. Therefore
you will have more light points but with
lower intensity.
30
All the PowerSpot thermoelectric gen-
erators can be connected in a series or
in parallel, increasing therefore the to-
tal available power for the same circuit.
If you wish to fit this kind of installation,
Powerspot offers the adequate peripher-
al cable.
Also, all the PowerSpot generators can
send power to a pre-existent electri-
cal installation in a house. For that, the
generated electricity can be sent to each
socket of the electrical installation so this
is fed by it. Substituting light bulbs al-
ready installed by 12V LED bulbs, or by
the ones manufactured by PowerSpot,
and unplugging those devices that re-
quire more than 15W (TV sets, fridges
etc.), the power will reach any socket al-
ready existing in a house.