Adjusting The Nailing Depth; Changing The Exhaust Direction; Using The Nose Cap - Metabo HPT NT 50AE2 S Instrucciones Y Manual De Seguridad

NOTE
If all warnings and instructions are followed, safe
operation is possible with two systems: SINGLE
SEQUENTIAL ACTUATION MECHANISM, and
CONTACT ACTUATION MECHANISM.
Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of metabo HPT pneumatic
tool lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.

ADJUSTING THE NAILING DEPTH

WARNING
When adjusting the Adjuster, be sure to
remove your fi nger from the trigger and
disconnect the air hose from the nailer.
To assure that each nail penetrates to the same depth, be
sure that:
1) the air pressure to the Nailer remains constant
(regulator is installed and working properly), and
2) the Nailer is always held fi rmly against the workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 DISCONNECT AIR HOSE FROM NAILER.
Adjuster
2 If nails are driven too deep, turn the adjuster to the
shallow side.
Turn adjuster
2
Too deep
If nails are driven too shallow, turn the adjuster to the
deep side.
000Book_NT50AE2_US.indb 17 000Book_NT50AE2_US.indb 17
15 Disconnect
air hose
Flush
Turn adjuster
2
Too shallow
3 Stop turning the adjuster when a suitable position is
reached for a nailing test.
4 Connect the air hose.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
5 DISCONNECT AIR HOSE FROM NAILER.
6 Choose a suitable position for the adjuster.
NOTE
The nail might not drive deep enough if using high
pressure with the adjuster set upwards (shallow side)
due to factors such as the material hardness or nail
type.
If that happens, reduce pressure and set the adjuster
to lowest position so the nail drives in at a good
position.

CHANGING THE EXHAUST DIRECTION

WARNING
When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The direction of the exhaust vent can be changed by
turning the top cover.
Exhaust vent

USING THE NOSE CAP

WARNING
When detaching or attaching the nose cap,
be sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The nose cap is attached to the push lever tip to protect
the workpiece from scratches or damage. Remove in the
order shown below when not using.
1 DISCONNECT AIR HOSE FROM NAILER.
English
Flush
Top cover
17
2018/03/22 15:09:06 2018/03/22 15:09:06