Electrical Connections - Sime DEWY EQUIPE 360 BOX Manual De Uso

IT
ES
2. 1 0 ELECTRICAL
CONNECTIONS
GB
Each module is supplied with a power cord
which, if replacement is required, must be
2. 1 0. 1 "DEWY EQUIPE 60 BOX/P60 BOX" wiring diagram
KEY
EV1 Gas valve coil
EV2 Gas valve coil
EA
ER
TS
V
TPA Water pressure transducer
PI
SA
SM Heating probe
TR
PD
SV
TF
PA
TRA Ignition transformer
76
ordered from SIME.
230V – 50 Hz single phase voltage is
required using a fuse protected main swit-
ch with at least 3 mm. between contacts.
Observe the L – N polarity and grounding
Ignition electrode
Detection electrode
Safety thermostat 100°C
Fan
System pump
Water trap frost sensor
230 – 24V transformer
Differential pressure switch
Fan board
Exhaust thermostat
Air pressure switch
J7 J6 J5
J8
J10
J9
RSA Resistance 100 (Ω)
R Resistance*
* The resistance in sequence/cascade installations is supplied in RVA
47 unit kit cod. 8096301/08. Use the resistance according to
module use (Boiler 1,2,3 or 4).
NOTE: Fan control board (SV) "MAX" and "MIN" trim-
mers are sealed and must never be tampered with.
CONNECTOR SPARE PART CODES:
J2 cod. 6278613
J3 cod. 6299971
J4 cod. 6293595
J5 cod. 6293594
J7 cod. 6293593
connection.
NOTE: SIME shall not be liable for any
damages to persons and things due to
lack of boiler grounding.
J4
J3
J2
J1
Fig. 11