Troubleshooting - Mr Coffee BVMC-KG2 Manual Del Usuario

Step 3: Close the lid, and perform a brew into the ceramic
mug without adding a K-Cup
Step 4: Pour the contents of the ceramic mug into the Hot
Water Tank, careful the liquid will be hot, close the
lid. Start a brew but power off the Brewer just after it
starts to dispense and then allow it to sit for at least
30 minutes.
Step 5: After the prescribed period of time, perform a brew
without adding a K-Cup
the ceramic mug into the sink, be careful as contents
may be hot.
Step 6: Fill the Hot Water Tank with 8 ounces of bottled
water, close the water fill lid, place a cup on the Drip
Tray Plate and perform a brew.
Step 7: Repeat Step 6 three times using bottled water (with
no K-Cup Pack in place) to cleanse the Brewer
®
plumbing and get rid of any residual taste from the
vinegar. The Brewer is now ready for normal use
again.
BVMC-KG2_11ESM1.indd 15-16
Pack.
®
Pack. Empty the contents of
®
14
TROUbLEShOOTING yOUR SINGLE SERvE bREWER
Beyond these recommended cleaning and maintenance
procedures this Brewer is not user serviceable, for service
please refer to the Warranty section in this guide.
PRObLEM SOLUTION
Brewer does not Make sure the Power Button is pressed
have power and is illuminated.
Plug Brewer into an independent outlet.
Check to be sure that it is plugged in
securely.
Plug into a different outlet.
Brewer will not If Brewer is cold/frozen, wait for at least
brew when used two hours for it to reach room tem-
for the first time perature before powering on.
Brewer will not Check to make sure there is water in
brew the Hot Water Tank.
Brewing a partial The Exit Needle may be clogged (refer
cup to page 12).
Clean K-Cup
and rinse under faucet (refer to page 12).
De-scale the Brewer (refer to page 13).
If you have repeated the de-scale
procedure on your Brewer two times
and the Brewer is still not brewing,
contact Customer Service.
Pack Holder if necessary
®
15
2/1/12 2:50 PM