SEVERIN SM 3798 Instrucciones De Uso página 11

Short-time operation
The appliance is designed to process
average domestic quantities of food. With
the blender or chopping attachment, it
may be operated without interruption for a
maximum of 1 minute at any switch setting,
after which it should be allowed to cool down
for approximately 3 minutes. When using
the whisk attachment, it may be operated
without interruption for a maximum of 2
minutes at any switch setting. Allow it to cool
down to room temperature for approximately
3 minutes afterwards.
Operating button
The blender is equipped with 2 push-type
operating buttons and a speed control.
Operating button
the speed can be adjusted with the speed
control.
Operating button TURBO:
highest speed setting.
Operation
∙ When fi tting the blender attachment to the
drive unit, ensure that the arrow mark on
the drive unit and the open-lock symbol
on the attachment are aligned: to lock,
turn the attachment so that the arrow is
aligned with the lock symbol.
∙ Always use a suitable container for
operation. A tall container with a fl at base
is best.
∙ Push the blender attachment down into
the ingredients in the bowl before briefl y
switching the appliance on with the
operating or turbo button.
∙ Make sure that the unit can rotate freely
inside the bowl and is not blocked during
operation.
∙ As soon as the operating or turbo button
:
is released, the appliance will switch off.
Always wait until the motor has come to
a complete standstill before lifting the
blender attachment from the mixture.
∙ Always remove the plug from the wall
socket after use.
Attachments
Always wait until the motor has come to a
complete standstill and remove the plug
from the wall socket before changing any
attachments.
The attachments are fi tted to the drive unit.
Ensure that the markings on the drive unit
and attachments are correctly aligned.
Chopping attachment
∙ Caution: Exercise extreme care: the
blades are very sharp. When handling the
blades, always hold them by the upper
protective plastic covering.
∙ Fit the cutting blade unit into the bowl
before fi lling the bowl with the food to be
chopped.
∙ Place the lid on the bowl.
∙ Attach the drive unit to the lid of the bowl
and turn to lock; ensure that the arrow
and lock symbols are properly aligned.
∙ Insert the plug into the wall socket and
press the turbo button in brief bursts
until the mixture has reached the desired
consistency. During processing, the lid
and bowl should be securely held in
place.
∙ Avoid overfi lling the bowl; it may be fi lled
with herbs etc. up to two thirds maximum.
Before the bowl is fi lled, the food to be
processed should be cut into pieces of
about 1 cm.
∙ Do not fi ll the bowl with hot liquid or hard
material such as ice cubes, nutmegs,
11