Craftsman 536.881113 Manual De Usuario página 29

11. Remove the three fasteners that
hold the friction wheel to the hub
(see Figure 40).
12. Remove the friction wheel from the
hub. Slip the friction wheel offthe
hex shaft.
13. Assemble the new friction wheel
onto hub with the fasteners re-
moved earlier.
14. Install the hex shaft and bearings
with the four bolts removed earlier
(see Figure 41).
Make sure the washers are prop-
erly installed in the original posi-
tion. Also, make sure the two
washers are properly aligned
with the actuator arms.
15. Make sure the hex shaft turns free-
ly.
16. Install the right wheel, axle, and
drive sprocket with the fasteners
removed earlier. Install the chain
onto the drive sprocket (see
Figure 38).
17. Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
18. Make sure the friction wheel and the
disc drive plate are free from grease
or oil.
19. Install the bottom panel (see
Figure 37).
20. Tighten the bolts on each side of
the bottom panel.
21. Install the left wheel to the axle
with the fasteners removed earlier.
22. Connect the spark plug wire.
Friction
Fasteners Hub Wheel
Hex Shaft
Fasteners
Figure 40
Actuator Arms \
Bearings
\
Washer
i/,_Vasher
Bearings
/
Washer
Washer
Figure 41
F-021050L 29