Status Information - NEO NEXUS DUAL SPLIT RDM Manual De Usuario

Failure Behaviour
For each of the two input universes, one of two fail-
ure behaviours can be chosen under Menu > Input A
> Failure Behaviour (Home > Menu > Input B > Failure
Behaviour).
The failure behaviour determines how the respective
universe reacts at the occurrence of a failure. Gen-
erally, it is considered a failure when no valid DMX
signal is observed at the input for the duration of
one second. If the universe is in DMX and RDM mode
however, it is considered a failure only if neither a
valid DMX frame nor the beginning of an RDM mes-
sage is observed for one second.
Off
No DMX is sent on the outputs. In the modes DMX
and RDM and Classic DMX the outputs continue to
forward whatever arrives at the inputs.
Hold Last Look
The outputs of the universe continue sending out
the last received look. If no data has been received
before, no data is sent to the outputs.

Status Information

Status information about each of the inputs is
accessible under Home > Menu > Input A > Status
Information (Home > Menu > Input B > Status Infor-
mation). As a shortcut, the button on the left below
the respective input port can also be used to recall
this information. Further details about this menu are
explained on page 14 under DMX Input Monitoring
and Diagnostics.
Output Settings and Information
Linking Outputs to Inputs
Output ports can be linked to
one of the two inputs under
Home > Menu > Output N, where
N stands for the number of the
P. 10
Neo Nexus Dual Split RDM - English version
output. The number of each output is printed on
the left above each XLR output port. As a shortcut,
the button on the left below each output port
(button [1] – button [8]) can be used to access the
same menu.
From the menu depicted above, the navigation
buttons or the button on the left below the output
port can be used to change the universe to which
the output port is connected.
DMX Output Mode
The DMX output mode is configured per universe.
See DMX Mode.
Failure Behaviour
The failure behaviour is configured per universe.
See Failure Behaviour above, under Input / Uni-
verse Settings and Information.
Device Settings and Information
Label
The device label can be viewed and edited under
Home > Settings > Label.
1. Using UP and SOWN buttons to choose the
position of text wanted to edit, press ENTER to
confirm.
2. Using UP and SOWN buttons to choose text
wanted to edit, press ENTER to confirm.
3. Cycling setp 1 & setp2 until editing finished
4. Press MENU button, then press ENTER to save
or MENU to discard.
Information
The following information about the device is
available under Home > Menu > Settings > Infor-
mation.