Mains Connection - NEO NEXUS DUAL SPLIT RDM Manual De Usuario

Mains Connection

The user must supply a suitable power cable. He
may then either hard-wire the power cable to the
building's electrical installation, providing an easily
accessible power on/off switch close to the device,
or install on the power cable a grounding-type
(earthed) mains plug that is suitable for the local
power outlets, following the power plug manufac-
turer's instructions. Consult a qualified electrician,
if you have any doubts about the proper installation.
A blue powerCON cable mount connector must be
used to supply power at the LF-SP28-3P 's power
input socket.
6. DMX CONNECTIONS
Depending on the version, the Nexus Dual Split
RDM is equipped with 5-pin or 3-pin XLR connectors.
XLR Connectors
Pin Connection
1 Com
2 Data -
3 Data +
4 Not connected
5 Not connected
The DMX inputs are fully isolated. All outputs are
isolated transmitters with a bias network for RDM
operation. Each output port is individually optically
isolated, meaning that it is totally isolated from the
other output ports and from the input section.
Warning! For protection against dangerous
electrical shocks, the device must be grounded
(earthed). The local AC power source must be sup-
plied with both overload and ground-fault (earth
fault) protection.
Important! Only attach or remove a powerCON
connector while it is connected to the mains to
apply or cut power in an emergency situation, as
by doing so may cause arcing at the terminals that
will damage the connectors.
5-Pin XLR male 5-Pin XLR female
(DMX in) (DMX out)
3-Pin XLR female
3-Pin XLR male
(DMX out)
(DMX in)
English version - Neo Nexus Dual Split RDM
P. 7