Battery Status - LD Systems LDU500CS4 SERIES Manual De Usuario

press the switch corresponding to the desired microphone station (RX 1 - 4). After approximately 10 seconds of inactivity, the display will
automatically return to the main screen. Synchronise the microphone station with the radio frequency set in the receiver as described in IR
SYNC RUN.
Note: Only frequency channels which are not already used by another microphone station can be set.
SQUELCH
The squelch control prevents unwanted background noise when the transmitter is turned off. In addition, sudden background noises are suppressed
when the signal transmitted from the transmitter to the receiver is not strong enough (for instance because of excessive distance) Set the squelch
control (with the transmitter switched off) to the lowest setting, which still effectively suppresses background noises. With an increased squelch
level and in unfavourable conditions, the transmission range may decrease. Press the switch corresponding to the desired microphone station (in
this example RX 1 = MIC 1) and then press the pressure rotary encoder
PUSH TO ENTER. Now select the SQUELCH menu item by rotating the encoder (light background) and press the encoder 2x to adjust the squelch
level as desired (00 - 50 dB) by rotating the encoder. Confirm the entry by pressing the encoder. If you press the encoder only 1x, you can exit this
menu item without changes by rotating the encoder and selecting the arrow symbol (light background) and confirm by pressing the encoder. To
return to the main display, select EXIT now by rotating the encoder (light background) and confirm by pressing the encoder. Then press the switch
corresponding to the desired microphone station (RX 1 - 4). After approximately 10 seconds of inactivity, the display will automatically return to the
main screen.
EXIT (in the microphone station menu)
To return to the main display, select EXIT on the encoder by rotating the encoder (light background) and confirm by pressing the encoder.
Then press the switch corresponding to the desired microphone station (RX 1 - 4). After approximately 10 seconds of inactivity, the display
will automatically return to the main screen.

BATTERY STATUS

The battery status of the microphone station will appear in the display and is constantly updated. When the batteries are fully charged, the
symbol ( = approx. 70%, = approx. 30%) will appear. As soon as the charge of the batteries is low, the display on the transmitter
will show "LOW BATTERY" and the display on the receiver "LOW BATTERY" approximately every 4 seconds, and the number of the microphone
station with low batteries will be displayed. Replace the batteries immediately.
13