Input Connections - Sony XM-GS6DSP Manual De Instrucciones

Input connections

Set the SELECT switch to the appropriate position
according to the speaker system.
2ch/BT mode and 6ch mode
Select "2ch/BT" or "6ch" mode depending on the
use/non-use of the DSP.
When selecting the "2ch/BT" mode, also select the
sensitivity "2V" or "5V" depending on the pre-
output level of your car audio unit.
Mode For
 using this unit as a 6ch amplifier (no
built-in DSP is used)*
the connections, see:
– " Line input connection (for
Subwoofer BTL system/6ch mode)"
(page 11).
– " High level input connection (for
Subwoofer BTL system/6ch mode)"
(page 12).
 using this unit with a 3-way speaker
system. With this connection, a 3-ways
speaker system can be driven without
a crossover network. For details on the
connections, see:
– " Line input connection (for 3-way
speaker system/6ch mode)"
(page 11).
– " High level input connection (for
3-way speaker system/6ch mode)"
(page 13).
 encoding 2ch input signals into 4.1ch
output signals (the built-in DSP is
used). For details on the connections,
see:
– " Line input connection (with DSP
enabled/2ch mode)" (page 10).
– " High level input connection (with
DSP enabled/2ch mode)" (page 12).
 playing a BLUETOOTH device by
operating the "Sony | Music Center"
application. For details, see "Playing a
BLUETOOTH Device" (page 16).
Setting the sensitivity "2V" or "5V" of the
"2ch/BT" mode. Normally, use this unit
set to "2V".
When using a car audio unit with a high
pre-output level, set to "5V" if the sound
is distorted while increasing the volume.
10
GB
1 . For details on
*1 While a bridged subwoofer connection is made, this
unit functions as a 5ch amplifier.
*2 When adjusting the volume balance of the front
speakers, rear speakers and subwoofer while the
unit is in 2ch mode (DSP mode), operate your
iPhone/Android smartphone to adjust the [Fader],
[Balance] and [Subwoofer Level] settings of the
"Sony | Music Center" application.
*3 The sound settings of the DSP (page 17) can be made
by the "Sony | Music Center" application on the
iPhone/Android smartphone. Before setting,
operate your iPhone/Android smartphone to
establish the BLUETOOTH connection with this unit
(page 15).
 Line input connection 
(with DSP enabled/2ch mode)
With the speaker connection  (page 14)

Notes
 When making this connection, set the SELECT switch
to the "2V" position.
 Set the SELECT switch to the "5V" position if the
sound is distorted when increasing the volume of the
car audio unit (only for car audio unit with a pre-
output level of 5 V).