Various Playback
This chapter describes various functions for
playback.
Playing a disc
SOURCE
./>
.
m/M
m
AUDIO
SETUP
SEARCH
SEARCH
PROGRAM
1
Number
4
buttons
7
CLEAR
1
Open the monitor and adjust the tilt and
swivel.
2
Press (POWER) to turn on the player.
On the card remote commander, press
.
The monitor turns on and the green light of
the POWER switch on the player lights up.
3
Press (PUSH OPEN) to open the disc
cover.
14
x
`/1
`/1
u
>
x
u
/y
M
y
SUBTITLE
ANGLE
REP
REP
TOP MENU
MENU
V/v/B/b
ENTER
PROGRAM
O
2
3
ENTER
5
6
VOL
VOL
8
9
DSPL
0
4
Place a disc with the label side up and
push around the center of it.
5
Close the disc cover by pressing
(PUSH OPEN).
Playback starts automatically.
If a disc is already inserted or playback
does not start automatically, press u to
start playback.
6
Press (VOL) (+) or (VOL) (–) ((VOLUME)
(+) or (VOLUME) (–) on the monitor) to
adjust the volume.
To turn off the power
Press (POWER) (or
commander) so that the green light of the
POWER switch on the player turns off.
After use
Turn off the player and disconnect the power
cord from the power source.
Note on using the player in the car
Using the player while the ignition key is in
ACC position and the engine is stopped may
cause the car battery to run down.
Notes
• Read the instruction manual supplied with the
disc to play with this player.
• Do not open the disc cover during playback.
• Depending on the recording method used on the
disc, it may take a minute or more before
playing.
• Depending on the condition of the disc, it may
not play back (page 37).
• A high-bit rate MP3 file such as 320 kbps may not
play back properly.
• A large-sized JPEG file may take some time to be
displayed.
on the card remote