Setting the FM transmitter
When using the player in the car, you can
transmit the audio signals to the FM radio and
output the signals from the car stereo. Do the
procedure below to turn on or off the FM
transmitter and select the frequency.
1
Press (S-MENU) on the monitor
repeatedly until the "FM Transmitter"
appears.
2
Press (VOLUME) +/– on the monitor to
select "On" or "Off".
3
To select the frequency, press (REVERSE)
on the monitor.
"Frequency" screen appears.
4
Press (VOLUME) +/– on the monitor to
select the frequency.
The settable range is 92.9 MHz to 102.9
MHz, in 0.2-MHz steps.
5
Press (REVERSE) on the monitor to
return to "FM Transmitter" screen.
When 5 seconds elapse with no button
pressed, normal display resumes.
Notes
• Depending on the location in which this player is
attached, FM signals may not reach the car radio
and audio output from the car stereo may
become interrupted. If this happens, adjust the
position of the FM transmission antennal or
move the reception antenna of the car radio
closer to the player.
• If noise is heard due to the interference with the
local FM broadcast, change the FM transmission
frequency.
• When the FM transmitter is turned off, you
cannot change the frequency setting.
34
Turning the image upside
down
To use the player in upright position, do the
following steps to turn the images on the
monitor upside down and switch the audio
channels.
Press (REVERSE) on the monitor.
"Reverse On" appears for 5 seconds and the
image on the monitor turns upside down.
To resume the normal images, press
(REVERSE) on the monitor again.
"Reverse Off" appears for 5 seconds.
Setting the reference
volume
You can set the reference volume level for
adjusting the volume by using (VOLUME) +/–
on the monitor.
Press (POWER) and press (VOLUME) +/–
on the monitor while no menu screen
appears.
The settable range is 0 to 47, and the default
setting is 10.
When you keep pressing down the button,
the value changes continuously.