Publicidad
Idiomas disponibles
Idiomas disponibles
Cable tracker
2) Use the sender (switch to "TONE"): Connect the test leads
to the subject pair, using the receiver touch the wire end
with clip lead, reception of tone is an indication of continuity.
*ATTENTION: DO NOT CONNECT TO ANY ACTIVE AC OR DC CIR-
CUIT IN THIS MODE.
Send tone:
Conect the test leads to the pair, or attach one lead to ground and one lead
to either side of the line. A dual alternating tone, or a single solid tone can be
selected from the switch inside the sender. Probe the suspected wires with
the receiver, reception of tone will be strongest on the subject wire. In case of
ready access to bare conductors, the receiver may be used to receive the tone.
*ATTENTION: DO NOT CONNECT TO ANY ACTIVE AC CIRCUIT EXCEED-
ING 24V IN THIS MODE.
Track cables or wires:
Use sender (switch to "TONE") and Receiver. Connect the test leads to the pair, or
attach one lead to ground and one lead to either side of the line, using the receiver
close to and along the object pair, and reception of the tone is indication tracking.
*ATTENTION: DO NOT CONNECT TO ANY ACTIVE CIRCUIT IN THIS MODE.
Identify the state of working telephone line:
Use sender (switch "OFF")
1) Identify TIP & RING. Connect the red test lead to the side of one line
and the black lead to the another side of line.
• "CONT" indicator light is green when you connect the red test lead to
the ring side of line.
• "CONT" indicator light is red when you connect the red test lead to
the TIP side of line.
2) Identify CLEAR, RINGING, BUSY state on the working telepohne line:
Connect the red test lead to the RING side, black to the TIP side.
• "CONT" indicator light is green, indicater a clear line.
• "CONT" indicator dose not glow, indicates a busy line.
• "CONT" indicator light brightly flickering yellow, indicates a ringing
time. (Switching to "CONT" will terminate the call on the subject line)
3) In cases of ready access to bare conductors, receiver may be used to
receive the tone.
7
Publicidad
