Stihl MS 291 C-Q Manual De Instrucciones página 38

English
Starting
Standard versions
N with the right hand, pull the starter
grip slowly until you feel it engage –
and then give it a brisk strong pull –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage! Do not let the starter grip
snap back – guide it vertically back
into the housing so that the starter
rope can rewind properly
With a new engine or after a long period
of disuse, with machines without an
additional manual fuel pump, it may be
necessary to pull the starter rope several
times – to prime the fuel line.
36
Versions with Easy2Start
The Easy2Start stores the energy for
starting the chain saw. For this reason, a
few seconds may pass between the
pulling of the starter rope and the
starting of the engine.
For versions with Easy2Start, there are
two ways to start the machine:
N pull the starter grip slowly and
smoothly – or – with the right hand,
pull the starter grip in several short
pulls of the starter rope, pulling the
rope out only a little bit each time
N during starting, press down on the
handlebar – do not pull out the
starter rope all the way – risk of
breakage!
N Do not let the starter grip snap back
– guide it vertically back into the
housing so that the starter rope can
rewind properly
Starting the chain saw
There must not be anyone within
the swivel range of the chain saw.
Versions with fuel pump
N Press the fuel pump bulb at least
five times – even if it is still full of fuel
For all versions
1
N
Push the hand guard (1) forwards –
the saw chain is blocked
N Simultaneously press the throttle
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position choke shutter closed l
– if engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position starting acceleration n
– if engine is warm (once the engine
has been running for approx. one
minute)
N Hold and start the chain saw
4
2
4
3
MS 291 C-Q