Bridge Mode / 70 V Operation - LD Systems CURV 500 IAMP Manual De Usuario

EXIT
To exit the selection menu and show the main display, turn the MENU dial to EXIT (light background) and confirm by pressing the MENU dial.

BRIDGE MODE / 70 V OPERATION

To set up a 70 V installation with the CURV 500 IAMP and CURV 500 satellites you require the LD Systems SmartLink adapter for 70 V
applications LDCURV500SLAT (available in black and white, please note the instructions in the user manual for the LDCURV500SLAT);
if you wish to use the speakON-compatible speaker output of the CURV 500 IAMP you require speaker cables with specially configured
speakON-compatible plugs, since two amplifier channels can be connected simultaneously in bridge mode in conjunction with the relevant
speaker preset. As an alternative to speakON-compatible plugs, you can use terminal block connectors (supplied, for configurations see
diagram CONFIGURATION OF SPEAKER OUTPUTS or label on the amplifier, recommended for speaker cables 2 x 1.5 mm²). Select the
preset corresponding to the number of satellites per SmartLink adapter as described under PRESET, then connect the CURV 500 IAMP and
the CURV 500 SLAT SmartLink adapter. It is advisable not to combine SmartLink adapters with differing numbers of satellites due to the
different preset settings. The maximum number of SmartLink adapters connected per bridge channel is derived from the number of CURV
500 satellites per SmartLink adapter.
Examples:
1 CURV 500 satellite per SmartLink adapter 70 V = maximum
of 24 SmartLink adapters (24 x 20 W = 480 W max.)
Speaker preset 1xC500-70V
2 CURV 500 satellites per SmartLink adapter 70 V = maximum
of 12 SmartLink adapters (12 x 40 W = 480 W max.)
Speaker preset 2xC500-70V
10
1 24
1 12
1 x LDCURV500SAT
LDCURV500SLAT
2 x LDCURV500SAT
LDCURV500SLAT