Adjust Solution Flow; Adjust Curtains; Adjust Wipers; Draining Solution Tank - FactoryCat MINIMAG Manual De Instrucciones

ADJUST SOLUTION FLOW:

1. Push UP (+) on the Solution Flow Toggle (A) to
increase the solution fl ow and push DOWN (-) on the
toggle to decrease solution fl ow (SEE BELOW).

ADJUST CURTAINS:

1. For Jaw curtains, release Jaw latch (B) and remove
Jaw Pin (C) on the front of the Jaws to open them
(SEE BELOW).
2. Loosen curtain band screws (D) (SEE BELOW).
3. To adjust curtain to the desired height, just slide the
curtain up or down in the slits and tighten screws.
4. Close Jaws - reconnect the latch and reinsert the pin.
D

ADJUST WIPERS :

1. For Cylindrical side wipers, loosen wiper band screws
(E) (SEE BELOW).
2. To adjust wiper to the desired height, just slide the
wiper up or down in the slots and tighten the screws.
E
M M -OP-ES
INI AG

DRAINING SOLUTION TANK:

To drain unwanted cleaning solution from the Solution
Tank, perform the following steps:
(SEE BELOW)
A
1. Pull the clear Sight Tube/Drain
2. Rinse out Tank and solution fl ow

DRAINING RECOVERY TANK:

Always empty Recovery Tank when refi lling the Solution
Tank. You can refi ll the Solution Tank while the Recovery
Tank is draining.
1. To drain the Recovery Tank remove Drain Hose
Leave Recovery Lid open while draining Tanks. Rinse
C
thoroughly.
B
Get Supervisor APPROVAL fi rst and drain at
APPROVED locations only.
G
Hose (F) off barbed fi tting.
system with clean water.
F
(G) from hook at rear of Tank and pop off cap (SEE
BELOW).
NOTICE
NOTICE
- 21 -