Deck Height Adjustment; Vacuum Motor; Solution Filter; Cleaning Solution Filter - FactoryCat MINIMAG Manual De Instrucciones

DECK HEIGHT ADJUSTMENT:

1. To adjust deck height for Brush / Pad clearance,
loosen jam nut on adjustment bolt (A), turn adjustment
bolt clockwise to raise Scrubdeck - counterclockwise to
lower Scrubdeck. Retighten jam nut (SEE BELOW).

VACUUM MOTOR:

1. The machine is equipped with a 24 volt,
.75HP Vacuum Motor (B) (SEE BELOW).
2. If foam or water gets past the Recovery Tank's Vac
Screen/Ball system, the "Unloader Valve" (C) will
drain it from the "Vac Box" (D) (SEE BELOW).
3. The Vacuum Motor has an (Optional) "Foam
Muffl er" (E) available to quiet machine operation.
B
D
- 24 -
A
E
C

SOLUTION FILTER:

The solution system has an "Inline Filter" (F) to fi lter out
cleaning solution prior to scrubbing (SEE BELOW).

CLEANING SOLUTION FILTER:

1. To clean the Solution Filter, fi rst unscrew the
clear cap (G) from house (I) and remove the
stainless steel screen (H) (SEE BELOW).
2. Rinse any debris
from the screen
with clean water.
3. Reinstall screen
and screw cap
back on tightly.
G
H
I
M M -OP-ES
INI AG
F