Accumulated Total; Parameters - Baxtran STD Manual Del Usuario

STD

6.4 ACCUMULATED TOTAL

6.4.1 Note
The scale can be set to accumulate manually by pressing the
for details of selecting the method using function "FS Prt". The accumulation function is only available
when weighing.
Please note before every accumulate operate, scale need return to zero, and only press
stable, when weight less than 20d, accumulate operate will be invalid.
6.4.2 Accumulate operate
The weight displayed will be stored in memory when the
ble.
The display will show "ACC 1" and then the total in memory for 2 seconds before returning to normal.
(after do accumulate operate, M+ indicator will turn on) If the optional RS-232 interface is installed
the weight will be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press the
key, the display will show "ACC 2" and then the new total.
Continue until all weights have been added.
Note: after you change weighing unit, accumulate value will be clear.
6.4.3. Memory recall
To view the totals in memory press
6.4.4. Memory clear
To clear the memory, just press
The scale has 8 parameters that can be set by the user plus a method of entering the calibration sec-
tion.
Turn off the power if you are using the scale. then turn on the power, press the
time during self-checking.
Display shows " Pn--- ", waiting for input password, Input password,
Then press the
The display will show the first function, " FO d iu "
Pressing the
Pressing will allow you to set the function. It may be necessary to either use
using the key to move the active digit and then using the
by the key to enter the value.
key in zero point (ZERO indicator on).
.
key to enter in.
key will cycle through the other functions.
. key. See the PARAMETERS Section
key is pressed and the weight is sta-

7. PARAMETERS

key at the same
key; key and
key to increment a digit, followed
User's Guide
key when
,
key.
or set a value
23