Making Connections; Speaker Connection - Sony XAV-AX8050D Manual De Instrucciones

*1 Not supplied
*2 Speaker impedance: 4 Ω to 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for a wired
remote control (not supplied).
For details on using the wired remote control, see "Using
the wired remote control" (page 14).
*5 Depending on the type of car, use an adaptor (not
supplied) if the antenna (aerial) connector does not fit.
*6 Whether in use or not, route the microphone input cord
so it does not interfere with driving operations. Secure
the cord with a clamp, etc., if it is installed around your
feet.
*7 For details on installing the microphone, see "Installing
the microphone" (page 14).

*8
*9 Set [Antenna Power] to [ON] (default) or [OFF] depending
on the type of DAB antenna (aerial) (not supplied).
Max. supply current 0.1 A

Making connections

If you have a power antenna (aerial) without a relay
box, connecting this unit with the power supply
leads  may damage the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8

Purple
Purple/black

striped

Gray

Gray/black striped

White
White/black

striped

Green
Green/black

striped
 To the car's power connector
continuous power
12
supply
power antenna (aerial) /
13 power amplifier control
(REM OUT)
switched illumination
14
power supply
15 switched power supply
16 ground (earth)
 To the parking brake switch lead
The mounting position of the parking brake
switch lead depends on your car.
Be sure to connect the parking brake lead (light
green) of the power supply leads  to the
parking brake switch lead.
Parking brake switch lead
Hand brake type
 To the +12 V power terminal of the car's rear
lamp lead (only when connecting the rear
view camera)
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.

Speaker connection

• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Yellow
Blue/white striped
Orange/white
striped
Red
Black
Foot brake type
13
GB